The material used to make your inflatable
has a permeable membrane required for proper use of the continuous
airflow that keeps your bouncer inflated, as well as seams that allow
air to escape. Naturally, some water may start to build up inside of the
water slides and parks. To evacuate most of the water, please follow
the below instructions, every time the inflatable is used:
DISCONTINUE PLAY/USE OF THE PRODUCT BEFORE DRAINING OR POWERING OFF.
DRAIN WATER FROM MAIN POOL
- If possible tip inflatable, while inflated, so all the water runs out of the pool
- If this is impossible, shut off the blower, and allow the unit to deflate to drain.
- Once all the water is out of the main pool, re-inflate it, and tie off any air outlets.
Dry the Product from the inside-out.
- Identify if any substantial amount of water is inside the main inflated bladder.
- If substantial water IS inside the inflated bladder:
- Leave the motor running, and with two adults, guide the water inside the product toward the open outlet tube.
- Water may encounter a series of membranes it will have to "bleed" through, which can make this process take time.
- Once the majority of the water has been evacuated through the outlet tube, allow the product to continue running until dry.
- In order to avoid water inside the bladder, arrange the
product when in use so the font pool wall is downhill and water does not
pool against the main bladder.
- If Substantial water is NOT inside (typical use):
- After draining the pool, re-inflate the product, and tie all
outlets shut. Allow the product to run until the material is visibly
dry, and no further bubbles appear on the seams.
- Open the small outlet tube, and continue to let air
circulate through the product until it is dry inside. You may look
through the outlet tube to see if there is any visible moisture inside.
Article ID: 3, Created: 6/17/2011 at 2:23 PM, Modified: 7/21/2011 at 9:30 AM